You seem to be offline
If performance and reliability are important to you AND you have equipped your Mazda with a Turbocharger or Supercharger; then an oil catch can is a critical component for your 2014-2018 Mazda3 and 2013-2017 Mazda 6 SkyActiv engine. Cylinder blow of gases and oil vapor build up in the engine crank case during normal and boosted spirited driving situations. The OE design utilizes a PCV valve to pull these gases and vapors into the intake manifold to be recycled through the combustion process. A byproduct of this process is excessive buildup of contaminants in the intake manifold and cylinder head, especially on the top of the intake valves. This causes negative effects on performance and efficiency as well as potentially causing expensive servicing or repair. The CorkSport Oil Catch Can provides an additional step in this process to help filter out contaminates and vapors before they enter the intake manifold. This kit is specifically setup for forced induction. Due to the added boost pressure in the intake manifold while WOT, the routing and connections points need to change vs the Naturally Aspirated setups. #ZoomZoom!
Check out the installation instructions below. Share your performance review with the CorkSport community once installed!
The CorkSport OCC dual chamber design separates the inlet and outlet ports by a center pass through disc. This promotes the incoming gases, vapors, and contaminates to spin and condense on the outside wall before the air passes through the separation disc. The resulting fluids pool in the bottom of the OCC for drainage.
The OCC body, ports and dip stick are manufactured from 6061-T6 billet aluminum with internal and external brackets manufacturer from stainless steel for long lasting durability.
All required parts for installation are included with the CorkSport OCC Kit.
It will take you two hours to install the CorkSport Oil Catch Can Kit with our easy-to-use instructions.
2 Hour Install Time
No FAQ found