Remove the tendency to overpower the front tires under hard cornering and minimize traction-robbing body lean with the CorkSport Mazda 3 Rear Adjustable Sway Bar. Compressing inside suspension, the CorkSport Mazda3 Rear Sway Bar effectively increases the spring rate on the side of the suspension that is compressed most, and its adjustability allows you to fine-tune the handling. Each Mazda 3 sway bar includes machined 6061-T6 aluminum sway bar brackets which are more durable than the stamped steel design common with other sway bars and look sharp with an anodized black finish.

The CorkSport Advantage:

Adjustable:

The CorkSport sway is designed for adjustability. With two end link attachment points, the sway bar offer you the ability to change the stiffness between 94% and 175% stiffer than stock.

Single Piece:

A single piece is used to create the Mazda3 rear swaybar which adds strength by removing weak points such as welds. The sway bar is also CNC bent for precise fit and made from 25mm 4130 Steel. Finally, the bar is powder-coated with a durable blue finish able to endure rough road conditions

Bushings are included with CorkSport's Mazda sway bar brackets.

Billet Sway Bar Brackets:

Superior bracket design with grease fittings for easy servicing with 90a durometer polyurethane, CorkSport brackets and bushings are the last you will need. Once installed, the reduced bar movement gives you extra confidence when taking corners.

Additional Features:

Made in the USA: Engineered and manufactured by CorkSport in Vancouver, Washington.
Durable blue or black powder-coated finish: can survive the winter driving in areas where roads are salted for snow and ice.
CorkSport Service and Support: Receive a two-year limited warranty, full color installation instructions, all of the needed installation hardware, and knowledgeable telephone support.

How To Install The Mazda 3 Rear Sway Bar

It will take you 30 minutes to install the CorkSport Mazda 3 SRI with our easy-to-use instructions.

1 hour Install Time

1/5 Difficulty

2-Year Warranty

No CEL

If you're on the fence about making the decision to purchase this swaybar, make the plunge. You will not be disappointed.

Very easy to install and it shouldn't take more than a couple hours, and that is from start to finish with plenty of breaks in between. I noticed a dramatic improvement over the stock swaybar and this was at the middle setting. Thanks Corksport.

--Tom

Thomas O'Mara03/12/2011, 01:05 PM

Turn in is great, feels solid and being able to adjust it is very nice and easy.

Brad Hines02/25/2011, 07:43 PM

awesome turnout on my 2010 mazda3 i 2.0

Carlos De Oliveira02/03/2011, 05:39 PM

20 minutes to install on my 2010 Mazda5 (using air compressor). Great turn-in and neutral feel overall. This car also has AutoEXE springs on stock struts. This swaybar was set to the middle setting and is a perfect complement to the car. I like front wheel drive cars with stock front bars and bigger rear bars and this was perfect. Fitment was flawless too.

Alan11/01/2010, 01:24 PM

← Prev

1 2 34

Write a review

Will this bolt up to a 2012 MAZDA 3 6speed SkyActiv with no modifications to the parts?

Asked by ben | 11/29/2023, 03:01 PM | 1 answer(s)

New post