FREE CS Backpack!
Add $399 in Parts, Then Add Backpack!
Finally Use Code: CSBACKPACK
360-260-2675
Vancouver, WA

HRS

M-TH 9A-5P | F 9A-12P | SA-SU CLOSED

CorkSport Mazda Performance

Shipping Estimator Shipping Estimator

Get rates

Mazdaspeed 3 and Mazda 3 Urethane Exhaust Hangers 2010-2013

Write a review
 
Price: $59.99
Price in points:  What are Points? 60 points
Axl-6-087-10
+ −
Add to wish list

Mazdaspeed and Mazda 3 Urethane Exhaust Hangers

Mazdaspeed 3 urethane performance exhaust hangers

Keep your new exhaust firmly in place with CorkSport Urethane Exhaust Hangers. Combining a new exhaust system with the stock rubber exhaust hanger allows for movement under normal driving conditions and can cause a thumping of the exhaust touching the underside of your car when going over bumps or navigating potholes. Autocrossing or high performance driving can also result in movement during aggressive steering maneuvers. Installing the CorkSport exhaust hangers will limit the excessive movement of your performance exhaust and keep you system tightly in place.

The CorkSport Advantage

  • Made from firm, long lasting polyurethane
  • Stylish blue color and molded to an exact fit
  • Works with CorkSport, stock, and most aftermarket exhaust systems that use stock exhaust hanger diameter
  • Single exit set contains four hangers, dual exhaust set contains six hangers for a secure, precise fitment on the Mazda 3
  • CorkSport Service and Support: Receive full color installation instructions, all of the needed hardware and knowledgeable telephone installation support



Please note the quantity of the hangars in this kit is designed for the CorkSport Power Series Exhaust systems. If you are using the exhaust hangars with the factory exhaust system you will not have enough hangars for all mounting locations.


Install time                  1/5 Difficulty               2 year warranty       No CEL





very impossible to get them on????holes in urethane bushings are slightly too small to fit over the cone nose of the exhaust hangar rods so you either shave those down a bit with an angle grinder or you take a drill bit about the size of the urethane bushing holes and bore it out a little other wise idk how other ppl got them on without a car lift and some special 80 dollar tool probably, why must they make things so difficult and the instructions don’t even tell you how to put the new ones on other than use wd-40???? corksport makes parts but they clearly don’t test them on the cars. also why save every cool thing for the sped3’s there people out there trying to modify their normal mazda3’s who didn’t want to have turbo and gdi problems and all the other issues that come with the speeds
Bryan Feranec 09/07/2024, 10:17 AM
I got these when I bought the CBE and they are holding up well. Definitely higher quality than the original hangers so why shouldn't you buy these?
Chris Doms 06/17/2019, 08:47 AM
A little pricey but an upgrade very worthwhile. I upgraded this while upgrading my exhaust to the CorkSport cat-back system. When I took the stock ones off I was surprised how loose and old they appeared. Glad I did the upgrade. Still... a little pricey.
Mike 09/20/2018, 03:19 PM
Absolutely necessary for aftermarket exhaust! I wasn't having pronounced clearance issues, but was getting excess noise from exhaust pipe vibrations under load. These keep the exhaust nice and tight, not allowing for vibrations to propagate down the length of the pipe. Highly recommend.
Tim S 08/13/2017, 05:08 PM
These hangers are better than the stock. A must if you are upgrading your exhaust. I have the turbo back exhaust from Corksport and the exhaust seems to stay in place pretty well. Only reason I give 4 stars is that it doesn't come with hangers for the downpipe.
Joe 04/04/2016, 09:48 AM
Bought this with my CS test pipe and cat back exhaust and I must say its a MUST HAVE when getting an aftermarket exhaust. These keep the exhaust hugging the body as opposed to dangling and it's really beneficial when your low or slammed. And due to them being polyurethane they last way longer than the stock oem hangers.
Jose Robert 03/07/2016, 01:47 PM
Bought these exhaust hangers for my 2012 Mazdaspeed3 along with the Corksport Catback Exhaust and I am extremely impressed. OEM hangers are junk compared to these, virtually no movement what so ever and adds a little style underneath your car. An absolute MUST HAVE with any exhaust. No rattling, no banging, no movement, just perfect.
Jose Dejesus 10/16/2015, 04:43 PM
"Blue is the only option" should be your company slogan lol
Hunter Dannk 04/30/2015, 10:16 AM
Another awesome product from corksport! After installing a down pipe, it made my whole exhaust rattle like crazy and after installing the hangers, it all went away. I also installed the 80 duro insert into my CS race rear engine mount which i also highly recommend.
Vlad 10/10/2014, 05:08 PM
I have a Gen2 2013 Mazdaspeed 3 and a few weeks ago I installed an Ultimate Racing turbo back exhaust. When things got warmer I noticed the stock exhaust hangers were too soft and the exhaust was hitting the subframe portion where the pipe goes up and over. The clanking and squeaking was driving me nuts. Even when idle at a stop light, the exhaust would rattle. Today the Corksport urethane hangers were installed and immediately noticed the difference when it was still up on the hoist. Exhaust movement was dialed in better. No more annoying rattles and squeaks. I can now enjoy my ride again! Thanks CS!
Marc Mueller 06/04/2014, 03:07 PM
← Prev
1 2
Next →
Write a review
Mazda performance parts financing is available with CorkSport

Looking to finance your parts purchase and want to get 6 months NO interest on any purchase over $199? Click on the image above for more details.


Bryan Feranec
Comment
very impossible to get them on????holes in urethane bushings are slightly too small to fit over the cone nose of the exhaust hangar rods so you either shave those down a bit with an angle grinder or you take a drill bit about the size of the urethane bushing holes and bore it out a little other wise idk how other ppl got them on without a car lift and some special 80 dollar tool probably, why must they make things so difficult and the instructions don’t even tell you how to put the new ones on other than use wd-40???? corksport makes parts but they clearly don’t test them on the cars. also why save every cool thing for the sped3’s there people out there trying to modify their normal mazda3’s who didn’t want to have turbo and gdi problems and all the other issues that come with the speeds
Chris Doms
Comment
I got these when I bought the CBE and they are holding up well. Definitely higher quality than the original hangers so why shouldn't you buy these?
Mike
Comment
A little pricey but an upgrade very worthwhile. I upgraded this while upgrading my exhaust to the CorkSport cat-back system. When I took the stock ones off I was surprised how loose and old they appeared. Glad I did the upgrade. Still... a little pricey.
Tim S
Comment
Absolutely necessary for aftermarket exhaust! I wasn't having pronounced clearance issues, but was getting excess noise from exhaust pipe vibrations under load. These keep the exhaust nice and tight, not allowing for vibrations to propagate down the length of the pipe. Highly recommend.
Joe
Comment
These hangers are better than the stock. A must if you are upgrading your exhaust. I have the turbo back exhaust from Corksport and the exhaust seems to stay in place pretty well. Only reason I give 4 stars is that it doesn't come with hangers for the downpipe.
Jose Robert
Comment
Bought this with my CS test pipe and cat back exhaust and I must say its a MUST HAVE when getting an aftermarket exhaust. These keep the exhaust hugging the body as opposed to dangling and it's really beneficial when your low or slammed. And due to them being polyurethane they last way longer than the stock oem hangers.
Jose Dejesus
Comment
Bought these exhaust hangers for my 2012 Mazdaspeed3 along with the Corksport Catback Exhaust and I am extremely impressed. OEM hangers are junk compared to these, virtually no movement what so ever and adds a little style underneath your car. An absolute MUST HAVE with any exhaust. No rattling, no banging, no movement, just perfect.
Hunter Dannk
Comment
"Blue is the only option" should be your company slogan lol
Vlad
Comment
Another awesome product from corksport! After installing a down pipe, it made my whole exhaust rattle like crazy and after installing the hangers, it all went away. I also installed the 80 duro insert into my CS race rear engine mount which i also highly recommend.
Marc Mueller
Comment
I have a Gen2 2013 Mazdaspeed 3 and a few weeks ago I installed an Ultimate Racing turbo back exhaust. When things got warmer I noticed the stock exhaust hangers were too soft and the exhaust was hitting the subframe portion where the pipe goes up and over. The clanking and squeaking was driving me nuts. Even when idle at a stop light, the exhaust would rattle. Today the Corksport urethane hangers were installed and immediately noticed the difference when it was still up on the hoist. Exhaust movement was dialed in better. No more annoying rattles and squeaks. I can now enjoy my ride again! Thanks CS!
← Prev
1 2
Next →

Recommended Products Recommended Products

CorkSport 7th Gear
$99.99