Mazdaspeed and Mazda 3 Urethane Exhaust Hangers

Mazdaspeed 3 urethane performance exhaust hangers

Keep your new exhaust firmly in place with CorkSport Urethane Exhaust Hangers. Combining a new exhaust system with the stock rubber exhaust hanger allows for movement under normal driving conditions and can cause a thumping of the exhaust touching the underside of your car when going over bumps or navigating potholes. Autocrossing or high performance driving can also result in movement during aggressive steering maneuvers. Installing the CorkSport exhaust hangers will limit the excessive movement of your performance exhaust and keep you system tightly in place.

The CorkSport Advantage

Made from firm, long lasting polyurethane
Stylish blue color and molded to an exact fit
Works with CorkSport, stock, and most aftermarket exhaust systems that use stock exhaust hanger diameter
Single exit set contains four hangers, dual exhaust set contains six hangers for a secure, precise fitment on the Mazda 3
CorkSport Service and Support: Receive full color installation instructions, all of the needed hardware and knowledgeable telephone installation support

Please note the quantity of the hangars in this kit is designed for the CorkSport Power Series Exhaust systems. If you are using the exhaust hangars with the factory exhaust system you will not have enough hangars for all mounting locations.

Install time 1/5 Difficulty 2 year warranty No CEL

very impossible to get them on????holes in urethane bushings are slightly too small to fit over the cone nose of the exhaust hangar rods so you either shave those down a bit with an angle grinder or you take a drill bit about the size of the urethane bushing holes and bore it out a little other wise idk how other ppl got them on without a car lift and some special 80 dollar tool probably, why must they make things so difficult and the instructions don’t even tell you how to put the new ones on other than use wd-40???? corksport makes parts but they clearly don’t test them on the cars. also why save every cool thing for the sped3’s there people out there trying to modify their normal mazda3’s who didn’t want to have turbo and gdi problems and all the other issues that come with the speeds

Bryan Feranec09/07/2024, 10:17 AM

I got these when I bought the CBE and they are holding up well. Definitely higher quality than the original hangers so why shouldn't you buy these?

Chris Doms06/17/2019, 08:47 AM

A little pricey but an upgrade very worthwhile. I upgraded this while upgrading my exhaust to the CorkSport cat-back system. When I took the stock ones off I was surprised how loose and old they appeared. Glad I did the upgrade. Still... a little pricey.

Mike09/20/2018, 03:19 PM

Absolutely necessary for aftermarket exhaust! I wasn't having pronounced clearance issues, but was getting excess noise from exhaust pipe vibrations under load. These keep the exhaust nice and tight, not allowing for vibrations to propagate down the length of the pipe. Highly recommend.

Tim S08/13/2017, 05:08 PM

These hangers are better than the stock. A must if you are upgrading your exhaust. I have the turbo back exhaust from Corksport and the exhaust seems to stay in place pretty well. Only reason I give 4 stars is that it doesn't come with hangers for the downpipe.

Joe04/04/2016, 09:48 AM

Bought this with my CS test pipe and cat back exhaust and I must say its a MUST HAVE when getting an aftermarket exhaust. These keep the exhaust hugging the body as opposed to dangling and it's really beneficial when your low or slammed. And due to them being polyurethane they last way longer than the stock oem hangers.

Jose Robert03/07/2016, 01:47 PM

Bought these exhaust hangers for my 2012 Mazdaspeed3 along with the Corksport Catback Exhaust and I am extremely impressed. OEM hangers are junk compared to these, virtually no movement what so ever and adds a little style underneath your car. An absolute MUST HAVE with any exhaust. No rattling, no banging, no movement, just perfect.

Jose Dejesus10/16/2015, 04:43 PM

"Blue is the only option" should be your company slogan lol

Hunter Dannk04/30/2015, 10:16 AM

Another awesome product from corksport! After installing a down pipe, it made my whole exhaust rattle like crazy and after installing the hangers, it all went away. I also installed the 80 duro insert into my CS race rear engine mount which i also highly recommend.

Vlad10/10/2014, 05:08 PM

I have a Gen2 2013 Mazdaspeed 3 and a few weeks ago I installed an Ultimate Racing turbo back exhaust. When things got warmer I noticed the stock exhaust hangers were too soft and the exhaust was hitting the subframe portion where the pipe goes up and over. The clanking and squeaking was driving me nuts. Even when idle at a stop light, the exhaust would rattle. Today the Corksport urethane hangers were installed and immediately noticed the difference when it was still up on the hoist. Exhaust movement was dialed in better. No more annoying rattles and squeaks. I can now enjoy my ride again! Thanks CS!

Marc Mueller06/04/2014, 03:07 PM

← Prev

12

Next →

Write a review

Mazda performance parts financing is available with CorkSport

Looking to finance your parts purchase and want to get 6 months NO interest on any purchase over $199? Click on the image above for more details.

Tyler Hasenpflug

10/09/2012, 05:38 PM

Comment
Excellent product. Took away all of the exhaust movement, with my aftermarket CBE. Now my exhaust doesn't hit the under carriage of my car, when corning hard.

Sean Strout

01/27/2013, 08:26 PM

Comment
These go on very easy. Cut the old ones off. Once you put these on though, its a pain to get them off but thats the point isn't it? These work great. My exhaust stayed right where it should when i ran my car tonight after the install (DP, racepipe, CBE) and i really ran her hard tonight. Thank you CorkSport for another great product. And vibrations aren't bad from the exhaust like my friends :)

James

03/21/2013, 07:21 PM

Comment
Awesome!! My aftermarket exhaust flopped around like a dead fish and made all sorts of noises! My car sounded like a beater! Got these installed today and no more exhaust movement! Thanks Corksport!

Jeffrey

04/15/2013, 02:02 PM

Comment
First, I just wanna say, THESE ARE SUCH A HUGE IMPROVEMENT OVER THE OEM JUNK THAT MAZDA INSTALLS and they look soo much nicer too! Second, These should be recommended when ordering the Axle-Back Muffler Delete Exhaust System. Due to the increased vibration without the mufflers, the hanger on the mid pipe behind the test pipe was banging around underneath the car and it was unpleasant to say the least! And the rest of the system was soo loose, it looked terrible. These hangers are a great quality item and help alot with absorbing the vibrations and harshness and hold the exhaust with a firm grip and now the system hardly moves. If it wasn't for these hangers I was about ready to sell the Muffler Delete, but now I'm keeping it and wringing it out LOUD!! Thanks CorkSport for a great item, just recommend it with the Muffler Delete so the rest of your customers don't have to go through what I did. Keep up the great work for the Mazda(Speed) crowd!

Matt Grenauer

05/31/2013, 05:43 AM

Comment
My exhaust is not going anywhere unlike before. Great product. No more banging on my control arm.

Randy Scrivner

09/18/2013, 02:28 AM

Comment
Used these with a CP-E exhaust system perfect fit look good and easy to install. Hold my exhaust nice and tight.

Jose

10/05/2013, 11:10 PM

Comment
This fixed the issue of my CBE moving around and banging around making my 13 MS3 sound like an old beater.. outstanding.

James

01/27/2014, 04:51 PM

Comment
any chance of these coming in anything but blue?

CorkSport Reply:Blue is the only option.

Erick

03/14/2014, 04:56 PM

Comment
Had problems with my Ultimate Racing Catback moving around when going over speedbumps, now the exhaust stays solid and doesn't hit anything or squeak over bumps. Absolutely pleased with this product

Mike

04/05/2014, 04:11 PM

Comment
Have the UR catback and basically no longer wanted to drive my car because of how bad it banged around and squeaked. Wasn't to sure if I wanted to drop 60 dollars on some hangers, but I'm glad I did. Exhaust fits tight now and does not make any unwanted noises. Thanks corksport. 2013ms3

← Prev

12

Next →