CORKSPORT 2014+ Mazda 6 Axle Back Exhaust

Shipping Estimator Shipping Estimator

CORKSPORT 2014+ Mazda 6 Axle Back Exhaust

Price: $499.99
Price in points:  What are Points? 500 points
Constructed from 304 stainless steel and tig welded.
Add to wish list

Get added power and upgrade the look of your 2014+ Mazda 6 with the CorkSport Power Series Axle Back Exhaust.As a completely new vehicle the engineers at CorkSport were given free reign to design an axle back exhaust in the best way fitting to the graceful design of the Mazda 6. As always, the CorkSport Axle Back Exhaust was built using only the highest quality materials and design. This means the CorkSport Mazda 6 exhaust is constructed from T-304 stainless steel and is TIG welded with precision laser cut flanges and features full mandrel bending to eliminate any possible flow restrictions.

The CorkSport Advantage:
  • Stainless Steel T304 construction with 90mm stainless tips for corrosion resistance and a clean stylish look.
  • Mandrel bent, true 60mm piping for increased flow and more power from your engine
  • Save around 8lbs over the stock exhaust.
  • CorkSport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware and knowledgeable telephone support

Disclaimer: NVH (noise, vibration and harshness) in the cabin of your vehicle will be slightly increased by the installation of this exhaust, especially on vehicles equipped with an automatic transmission.

I installed the exhaust, cold air intake and strut tower brace on my 2016 6 touring.
I wanted to enhance an already fun to drive car. The combination of the intake and exhaust has transformed the throttle response, the power and torque have increased across the entire rev range. The car is quicker by the stopwatch and not just the 'butt dyno' Not sure of the accuracy of the times that I have gotten, but I used the same app on the with the same amount of gas in similar temperature conditions and several different launching techniques and the times before were close to what all of the car rags have reported and the car is definitely quicker now.
Plus it sounds awesome. There is a little bit more rumble when driving in normal conditions, but under heavy throttle, the sound is deep and just loud enough. It does NOT sound like a kazoo as so many other exhaust systems on 4 cylinders cars do.

Additionally, the strut tower brace helps make the car resist understeer and makes the platform feel more solid than it already was.

Next will be the sway bar for the rear..

This car is a blast. Thank you Corksport for quality parts. Thank you Mazda for making a fun competitor in this segment.
Amazing quality, fit & finish! The sound is phenomenal! Deep bass & video will not do justice! Install was a breeze & fits perfectly!
Do not hesitate! This made a world of difference for style, sound & class on my 2016 6!
Loving my new exhaust! I agree with others that the tone is much deeper than expected, which is a good thing. The cabin noise does increase, the exhaust can drone during acceleration and really increases on those cold mornings when the accelerated warm up system (AWS) kicks in to warm up the cats. If you are accustomed to the car being quiet this might take some getting used to for certain people. I am coming from a Speed3 with an aftermarket exhaust so it's a non issue for me. The installation was a breeze and the difference in size and weight versus stock is unreal! Construction of the CS exhaust is spot on with great craftsmanship! Another quality CS part for your Mazda.
Installation was simple, along with easy to read instructions; made this an easy upgrade. The exhaust note is deep and throaty while adding more volume. Cabin volume raises as well but it doesn't drone and at cruising speeds the volume dissipates, but when you give it gas especially at lower RPM'S like 3K it sounds mean and sinister. This also lighter then factory exhaust! over all quality is great, the welds are consistent, and the tips fill out the cut outs on the bumper just great.

A must get if you're looking for that sporty sound in your Mazda 6
If you are looking for a super loud exhaust this is not the one for you, but it does have a very nice deep grumble and you can clearly hear it from inside the cabin. Wasn't too difficult to install and instructions were very clear, great product overall.
Great exhaust! I really like the tone of it, it is much deeper than what I expected. The sound inside of the cabin is increased significantly, but if you're buying this you too probably appreciate that sound. One downside to the exhaust is the tone when you start it up with a cold engine. It very loud and drones a bit. If you park your car in a garage it only amplifies the problem. I probably wouldn't have noticed it as much had my wife not pointed it out. It is loud enough that it can be heard throughout our 1.5 story house in the morning when I start it. Install was very easy and I couldn't believe the size and weight of the factory exhaust that it replaced. If I had to guess it is probably a 25% or more weight reduction from the factory exhaust. Overall a very good product though.
Write a review

I just installed this exhaust and I want to say it's great. I just have one concern why werent the rear exhaust hangers used. Aren't you guys worried of extra stress now on the exhaust leading to the mufflers?

Asked by mike | 06/28/2016, 05:45 PM | 1 answer(s)

Hello how many DB sounds this Exhaust? Need this for Germany thx

Asked by Marco Feldner | 06/11/2016, 07:39 AM | 1 answer(s)

How much does this weight?

Asked by Vu | 01/14/2016, 09:19 AM | 1 answer(s)

What advantages does this exhaust have over the racing beat axle back for the Mazda 6?

Asked by Kev | 11/25/2015, 07:06 PM | 1 answer(s)

Have you guys dino tested this exhaust ?

Asked by Jasiel malpica  | 11/17/2015, 09:45 AM | 1 answer(s)

Will this cause my car to not pass EPA guidelines or inspections?

Asked by Ethan Hom | 09/12/2015, 05:33 PM | 1 answer(s)

How much HP gain?

Asked by John | 08/18/2015, 02:53 AM | 1 answer(s)

is this exhaust available for shipping in canada?

Asked by nhel | 04/14/2015, 01:52 PM | 1 answer(s)

is the flange on the exhaust angled down? also are the bolt holes same height or angled?

Asked by Sam Martin | 03/21/2015, 10:04 AM | 1 answer(s)

Six Months No Interest Financing on Purchases over $199!

Corksport understands that you may be ready to outfit your entire car with CorkSport Mazda Performance products, but want to use an alternative method of payment. Not to worry, we have a solution for you.

Click here for all the details of our Financing Options.