4 inch Intake System for the 2006-2007 Mazdaspeed 6

The CorkSport Advantage

Fitment Focused:

To make the Speed6 4 inch Intake the best, we rethought the way everyone has designed other intakes. The big change is with the MAF housing connection; instead of a silicone coupler to attach the MAF housing, the machined MAF housing is welded directly to the turbo inlet pipe. This gives you latitude to optimize fitment and filter size. You end up with a 4 inch intake that takes up less room than most 3.5” intakes while retaining all OEM mounting points, BPV, and PCV/boost vent ports.

Massive Power Potential:

4 inch intakes offer a bonus power potential. By moving up in intake diameter, you increase the maximum amount of air your Mazda 6 speed can ingest. With a retuned ECU, you also increase the amount of air the maximum the MAF sensor can read. Typically not offering a power bump on lower horsepower Mazdaspeed 6's already with big power can see an increase in power, just by reducing the airflow restriction before the turbo. The bigger diameter increases efficiency & increases the operating range of the MAF sensor to support over 900whp.

Optimized Filter:

The 4” Intake System reduces flow restrictions by using a huge air filter measuring 7 in length x 4.5 inches at the MAF inlet. Air Filter size is something most large intake systems ignore, which can ruin some of the benefits of going to a large intake. A larger pipe size does no good if your air filter flows poorly and/or is too small. You can see how much bigger this is than our normal filters in the picture!

Accurate Flow:

The Mazdaspeed 4 inch design may be a bit different from our typical intakes, the CS 4” intake still retains a billet aluminum MAF sensor housing. When combined with the pre-installed air straighteners it provides accurate airflow readings. The result is an easier to tune Mazdaspeed 6 ECU and will consistently read the actual amount of airflow entering your engine.

Materials & Manufacturing:

Each CorkSport 4” Intake System is made from mandrel bent 6061 aluminum tubing which ensures strength and smooth airflow into your turbo. The billet machined MAF housing and ports are TIG welded in place for upmost strength and reliability. The Speed6 intake pipe is wrinkle black powdercoated for a clean look that will last and match any engine bay. Also included is your choice of turbo inlet coupler made from 4-ply reinforced silicone. Turbo couplers size options are to fit 4.0”, 3.5”, and OEM sized compressor housings. Stainless steel T-bolt clamps are included to complete the intake kit with everything you need!

Additional Features

• Vehicle Fitment: 2006-2007 Mazdaspeed 6, 2005-2007 MPS6.
• Designed & Developed in America: Designed, tested, and validated in Vancouver, Washington, in the Pacific Northwest.
• CorkSport Service & Support: 2 year limited warranty, full color installation instructions, all necessary components, and knowledgeable telephone support at (360) 260-2675.