The CorkSport Performance Mazda6 Adjustable Struts and Shocks are designed for the driving enthusiasts that desire quality handling and comfort. The performance struts and shocks feature 15-position adjustable rebound damping to give you the freedom to tailor the ride quality and handling to your characteristics and suspension setup. Adjusting your performance struts and shocks is a simple and painless process; just simply pop open the hood and/or reach under the wheel well. Don’t settle for a bouncy, unrefined, and poor handle ride any further; take your Mazda 6 to the next level! #ZoomZoom!
Check out the installation instructions below. Share your performance review with the CorkSport community once installed!
Struts and shock play a very important role in your vehicle’s handling characteristics; they affect acceleration, deceleration (braking), cornering, and steering response. From the factory, your vehicle's damping rates and springs are paired correctly for the desired handling and ride comfort. This all changes when lowering springs with higher spring rates are installed.
Performance struts and shocks with higher damping rates are a critical component when using stiffer springs to bring that handling balance back. You may be concerned that this will have a negative effect on ride quality when the exact opposite is true. Increasing the damping rate to match the higher spring rate will improve all handling characteristics and reduce/remove the bouncy, uncontrolled feeling that some lowering springs can cause.
15-Position Adjustable Rebound Damping. Easily adjust your struts and shocks from OE specs to up to 70% higher rebound damping rate to tailor to your specific driving style and comfort level.
The CorkSport adjustable struts are designed for an easy OE fitment installation and operation. No extra components, hardware, or accessories are needed for installation and existing OE components can be used.
Adjusting the struts and shocks are an easy process front and rear. The front struts utilize a click-lock adjustable knob located at the top of the strut that can be easily accessed with the hood up. The rear shocks can be adjusted through access in the wheel well; removing interior panels is not required. For lowered vehicle setups, a hydraulic jack and jackstand may be required.
This package works well with CorkSport lowering springs and camber plates to make a whole suspension package for your car.
It will take you three to four hours to install the CorkSport Performance Adjustable Struts and Shocks with our easy-to-use instructions.
1 Hour Install Time
No FAQ found