Mazdaspeed 3/Mazda 3 Front Adjustable Sway Bar End Links
Description
Eliminate binding and remove the preload on your sway bar with Mazda 3 and Mazdaspeed 3 Adjustable Front End Links. Made to fit OE Mazda and aftermarket sway bars, the CorkSport End Links have +/-6mm of adjustability, use a 5/8" hex stock that will reduce end link fatigue, and have sealed end M10x1.5 ball joints for low friction and added durability.
The CorkSport Advantage:
- Sealed ball joint design: Offers low friction and is shielded for added durability and longevity
- Can be used with an OEM or aftermarket sway bar*
- Made from 5/8" hex stock 2011 T-3 Anodized Aluminum: For a long lasting finish and durability
- No Permanent Modification: Does not require enlarging the shock mounting flange holes
- Adjustable: +/- 6mm in adjustable length compared to stock to easily tune the sway bar as part of the suspension system.
- CorkSport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support
- Fitment: 2007-2013 Mazdaspeed 3, 2004-2013 Mazda 3
* The end links have been tested and confirmed for fitment with the CorkSport and OEM sway bar. They are likely to fit most aftermarket sway bars, however CorkSport cannot guarantee fitment with a sway bar if the end link holes are not within a reasonable approximation of the OEM end link holes.
Sold as Pair
How To Install the Mazdaspeed 3/Mazda 3 Front Adjustable Sway Bar End Links
It will take you Approx. 1 hour to install.
1 hour Install Time
2/5 Difficulty
2-Year Warranty
No CEL
Reviews
Gary cota
I just ordered Megan racing coil overs and was wondering if I need adjustable sway bar links so it lines up with the hole on the strut from the coil over or will it fit fine if i use oem sway bar links if I adjust my height of my car?
Yolandasampson
Will these work with the rear sway bar or are they just for the front?
Jonathan
how can i pay the item? can i use paypal? how much is the cost for delivery in mexico? zipcode 67480
jonathan
Can you send me the item to mexico? CorkSport Reply:Yes we can.
Dimitris
I have the same "clunk" sounds coming underneath the car when its is cold and hit bumps (after a while they stop). it must be my 5 year OEM endlinks. will these endlinks stop that "clunk" noise? thanks
Zach
I recently replaced my OEM's with the MOOG ones, but because of the zerk fittings, they rub when i turn full lock to full lock. These wont cause any rubbing issues will they? CorkSport Reply:There should be no rubbing issues with the end links.
Todd
I could get the factory end links to deflect a little bit with my hands. These are MUCH more rigid, and made turn-in a bit more crisp.
Stephen Fancy
are the corksport endlink bolts/studs 3/8"? +/- CorkSport Reply:They are M10
Stephen
Will these work with cobb front anti swaybar? cobb's bar has 3/8" holes approx CorkSport Reply:We have not fitted them here with the COBB swaybar.
mikevelasco
will this resolve the issue of the front end clunk? i have a 2007 mazdaspeed 3. Thanks Corksport !
New features
- Manufacturer
- Stock