The combination of the CorkSport Cold Air Intake System along with the VersaTuner Tuning Solution provides the best power output for your 2016-2021 (ND1 and ND2) Mazda MX-5.

Pairing the Versatuner Tuning Solution along with the CorkSport Performance Parts provides the best opportunity to get the most out of your Mazda Miata.

Combine and Save on your new CorkSport Performance Parts.

The CorkSport Advantage

Performance Gains

The Cold Air Intake Performance system along with the included Tune, bring your Mazda MX5 Miata to a whole new level. The combined CorkSport Performance Parts and ECU Tune provide increased horsepower and torque across the entire RPM range and an impressive 12 wHP and 8 wTQ increase @ 6500rpm.

Not only are the performance gains impressive, but the new intake induction noises and clean engine bay are truly eye-catching. Check out the CAI System at the link above!

Tuning Flexibility

The VersaTuner Tuning Solution allows you the ability to datalog, analyze, tune, and troubleshoot your Mazda Mx-5 Miata. Develop your own custom ECU Tune or use the provided CorkSport Calibration.

Additional Features

Compatible with: 2016-2021 Mazda Mx5 Miata CorkSport CAI Calibrated Tune
Advisory (RED): The provided ECU Calibration is for tuned for 92oct fuel. Use of 91oct fuel is not recommended; an optimized tune for your desired fuel type is strongly recommend.
CorkSport Service & Support: 2-year limited warranty, full-color installation instructions, all necessary components, and knowledgeable telephone support at (360) 260-2675.

How To Install Your

Cold Air Intake System along with the VersaTuner Tuning Solution

It will take you 3 hours to install with our easy-to-use instructions.

3 Hour Install Time

2/5 Difficulty

2-Year Warranty

No CEL

The intake installation was a piece of cake. The extra power gained from installing the tune was well worth it. I really recommend this kit.

Zachary Limon09/01/2017, 10:55 AM

Write a review

Does this function on the updated ND2 engine? I understand there are issues with the MAF sensor. I also see the dyno run is only for an ND1 with the old 151 WHP. When will an update for the ND2 be available?

Asked by Branden | 03/27/2022, 09:14 AM | 1 answer(s)