Mazdaspeed 6 Performance Exhaust System

Get a nice deep tone and solid power gains through your entire RPM band with the CorkSport Mazdaspeed 6 Exhaust This dual muffler design uses ovaled 80mm stainless steel tips and factory hanger locations for a perfect OEM fitment.

Constructed from quality materials and using only the best construction methods, the CorkSport exhaust is designed with mandrel bent 80mm polished T304 Stainless Steel piping for a smooth exhaust flow and increased power. The CorkSport Mazdaspeed 6 Exhaust also features TIG welds for a strong, good looking connection.

The CorkSport Advantage

Ovaled 80mm Stainless Steel Tips for corrosion resistance and a clean stylish look
Mandrel bent, true 80mm piping for increased flow and more power from your engine
Dual muffler design that provides a nice deep tone
CorkSport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware and knowledgeable telephone support

Install time 2/5 Difficulty 2 year warranty No CEL

how to install a Mazdaspeed 6 cat back exhaust

Hopefully they will release a 3.5in for the speed6, but in the meantime, this is the exhaust you want. Cold-start, idle, takeoff, WOT, and anywhere in between, this is by far the best sounding exhaust for a speed6.

Brandon01/25/2023, 01:08 PM

Just what the speed6 needed! Sound is fantastic paired with a catted downpipe. It can be rowdy under power and higher rpm but daily driving is mellow enough to be enjoyable. Great balance of daily and "track car". Install was good with the instructions. Any exhaust has its challenges with the various flanges and alignment but the end result is great.

James Dean01/18/2023, 09:08 AM

Beautifully made and superior fit and finish. Nice tone, definitely not quiet compared to stock. Though I also have the CS meow-less downpipe so I'm sure that adds some volume.

Scott Hayes08/18/2022, 12:08 PM

This exhaust is fabricated extremely well, and the sound is perfect for this car. Welds are strong and fits just right.

Blaine Phillips12/27/2020, 10:39 AM

Fits and looks good but after couple weeks sounds quiet even went I step on it sounds like the stock One when I rev sounds clogged ????????‍♂️ I expect more for that price

Dustin05/04/2020, 02:52 PM

Great fit and great look. Love the tig welds. Sound it a little bit loud with the downpipe I have installed but not bad.

Stefan Smith05/11/2017, 06:13 AM

Write a review

What is the width of this exhaust? Is it 2.5 or 3 inch exhaust?

Asked by Frank castle | 11/14/2022, 11:41 PM | 1 answer(s)