Shipping Estimator Shipping Estimator

2006-2007 Mazdaspeed 6 Lowering Springs

 
Price: $229.99
Price in points:  What are Points? 230 points
Ate-3-288-10
+
Add to wish list




Give your Mazdaspeed6 the performance appearance and edge you have been looking for with the CorkSport Lowering Springs for the Mazdaspeed6. By reducing ride height approximately 1.5" in the front and 1.6" in the rear, adding the CorkSport Lowering Springs to your Mazdaspeed 6 will result in a quicker turning response, crisper road feel, a more aggressive appearance, and a firmer spring rate, all while maintaining excellent ride quality.

The CorkSport Advantage:
  • Designed for and tested on the Mazdaspeed 6
  • Lower your car by approx. 1.5" front and 1.6" rear for improved handling and less wheel gap
  • Crafted from high tensile strength spring steel for long lasting quality and performance
  • OEM finish to ensure lasting durability and rust protection
  • Backed by CorkSport limited two-year warranty
  • CorkSport Service and Support: Receive full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support




Bought these springs to replace RPM Sport springs (discontinued) that had sagged over the last 10 years.

The Corksport springs were well packaged and came with great instructions. Install went smoothly.

Noticed a big improvement in handling and comfort on the test drive. Front ride height was perfect. The rear ride height was borderline, a little lower than the pictures, but I was happy with the improvement.

After about a month the suspension had settled and the front ride height was still ok. The rear however, was much lower than I would like. The rear springs are just plain too short and now the top of the rear tire is tucked under the fender when parked. The springs are installed correctly and there are no out of spec suspension parts in the front or rear.

If I had to do it over again I would skip this product. It's better than the dead springs I had, but at this point I would take factory springs.
really amazing i go t the springs in a couple days after i ordered them with complete instructions on how to install them. Very simple. The car is lower and does not scrape with very little wheel gap. i have a tighter feel in my suspension and absolutely love it. A definite buy
I already had Bilstein HD struts when I installed these springs and let me tell you, they are worth every penny. They have been on the car for a few weeks and I'm kicking myself for not doing this earlier! Perfect wheel gap and clearances for a road car, no rubbing on stock MS6 rims with 225/45/18 tires, even loaded the car up with no rubbing or ground contact. As with any lowering spring the ride is a bit stiffer but the pros far outweigh that slight con for street driving. Another great product by CS!
With These Springs on stock rims what would be the fattest tire you could fit? 235?



CorkSport Reply:Measure your setup and calculate what the extra width would be.
Write a review

If I have wheel spacers (5mm to clear your BBK on stock wheels) would I have any issue with wheel rub using these lowering springs?

Asked by Christopher Barrow | 07/12/2016, 10:28 AM | 1 answer(s)

Are the springs progressive or linear design?

Asked by Alex | 09/28/2016, 08:47 AM | 1 answer(s)

Can these lowering springs be used safely with OEM struts?

Asked by Dylan | 03/08/2016, 04:34 PM | 1 answer(s)

What is the spring rate? How much stiffer than the stock MS6 springs? Thanks.

Asked by Derek | 10/15/2015, 07:26 PM | 3 answer(s)

Looking to finance your parts purchase and want to get 6 months NO interest on any purchase over $199? Click on the image above for more details.