Mazdaspeed 3 and Mazda 3 Swaybar End Links

Eliminate binding and remove the preload on your sway bar with Mazda 3 and Mazdaspeed 3 Adjustable Front End Links. Made to fit OE Mazda and aftermarket sway bars, the CorkSport End Links have +/-6mm of adjustability, use a 5/8" hex stock that will reduce end link fatigue, and have sealed end M10x1.5 ball joints for low friction and added durability.

The CorkSport Advantage:

Sealed ball joint design: Offers low friction and is shielded for added durability and longevity
Can be used with an OEM or aftermarket sway bar*
Made from 5/8" hex stock 2011 T-3 Anodized Aluminum: For a long lasting finish and durability
No Permanent Modification: Does not require enlarging the shock mounting flange holes
Adjustable: +/- 6mm in adjustable length compared to stock to easily tune the sway bar as part of the suspension system.
CorkSport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support
Fitment: 2007-2013 Mazdaspeed 3, 2004-2013 Mazda 3

* The end links have been tested and confirmed for fitment with the CorkSport and OEM sway bar. They are likely to fit most aftermarket sway bars, however CorkSport cannot guarantee fitment with a sway bar if the end link holes are not within a reasonable approximation of the OEM end link holes.

Sold as Pair

How To Install the Mazdaspeed 3/Mazda 3 Front Adjustable Sway Bar End Links

It will take you Approx. 1 hour to install.

1 hour Install Time

2/5 Difficulty

2-Year Warranty

No CEL

I just ordered Megan racing coil overs and was wondering if I need adjustable sway bar links so it lines up with the hole on the strut from the coil over or will it fit fine if i use oem sway bar links if I adjust my height of my car?

Gary Cota05/01/2014, 02:54 PM

Will these work with the rear sway bar or are they just for the front?

Yolandasampson04/26/2014, 09:16 PM

how can i pay the item? can i use paypal? how much is the cost for delivery in mexico? zipcode 67480

Jonathan02/27/2014, 07:28 PM

Can you send me the item to mexico?

CorkSport Reply:Yes we can.

Jonathan01/18/2014, 06:59 AM

I have the same "clunk" sounds coming underneath the car when its is cold and hit bumps (after a while they stop). it must be my 5 year OEM endlinks. will these endlinks stop that "clunk" noise?

thanks

Dimitris01/13/2014, 04:42 AM

I recently replaced my OEM's with the MOOG ones, but because of the zerk fittings, they rub when i turn full lock to full lock. These wont cause any rubbing issues will they?

CorkSport Reply:There should be no rubbing issues with the end links.

Zach11/21/2013, 04:29 AM

I could get the factory end links to deflect a little bit with my hands. These are MUCH more rigid, and made turn-in a bit more crisp.

Todd08/10/2013, 06:51 AM

are the corksport endlink bolts/studs 3/8"? +/-

CorkSport Reply:They are M10

Stephen Fancy07/30/2013, 06:06 PM

Will these work with cobb front anti swaybar? cobb's bar has 3/8" holes approx

CorkSport Reply:We have not fitted them here with the COBB swaybar.

Stephen07/29/2013, 10:41 PM

will this resolve the issue of the front end clunk? i have a 2007 mazdaspeed 3. Thanks Corksport !

Mikevelasco01/14/2013, 06:18 PM

← Prev

123

Next →

Write a review

Any recommendations/endorsement/preference/etc for a rear end link brand?

Asked by Manny | 01/24/2023, 01:56 PM | 1 answer(s)

After 100k miles, is there any maintenance need for these end links? Do you offer replaceable parts if needed?

Asked by GCPhotographers | 09/14/2021, 08:08 PM | 1 answer(s)

Do I need to grease them?

Asked by Mitchell | 03/24/2021, 12:52 AM | 1 answer(s)

Will these help if your car is lowered on coilovers, or do I need longer links?

Asked by Ethan | 05/06/2019, 11:58 AM | 1 answer(s)

What is the dimensions of these from lowest to highest height?

Asked by dagrimey1 | 04/23/2019, 11:06 AM | 1 answer(s)

Is the listed price for one sway bar link or a set of two? IE Are you selling the link by the single part, or is this item a pair of links?

Asked by Charles | 12/19/2017, 11:54 AM | 1 answer(s)

does it fit on a ms6 ?

Asked by Jeremy Marcoux | 05/31/2016, 07:12 AM | 1 answer(s)

buy this part more than two years, whether sold parts and not have to buy everything.

Asked by Felix | 05/17/2016, 05:48 PM | 0 answer(s)

Will these work if you are lowered on bc coilovers? Or should I get ones that have a little more adjustability

Asked by ethan | 03/29/2016, 08:11 PM | 1 answer(s)

Do you habe this product for a mazda 3 2015?

Asked by Josue | 08/20/2015, 08:04 AM | 1 answer(s)

Any reason you guys haven't also started offering the rear end links?

Asked by Christopher Hyndman | 06/26/2015, 08:08 AM | 1 answer(s)

New post

Mazda performance parts financing is available with CorkSport

Looking to finance your parts purchase and want to get 6 months NO interest on any purchase over $199? Click on the image above for more details.

Shipping Estimator Shipping Estimator

Mazdaspeed 3/Mazda 3 Front Adjustable Sway Bar End Links

How To Install the Mazdaspeed 3/Mazda 3 Front Adjustable Sway Bar End Links

Recommended Products Recommended Products

About CorkSport

Shopping

Connect

Social links

SPONSORSHIP