Shipping Estimator Shipping Estimator

Mazda 3 Lowering Spring Set

 
Price: $209.99
Price in points:  What are Points? 210 points
Axl-3-287-10
+
Add to wish list




Give your car the performance appearance and edge you have been looking for with the CorkSport Lowering Springs for the 2004-2009 and 2010-2013 Mazda 3. By reducing ride height approximately 2.25" in the front and 1.75" in the rear, adding the CorkSport Lowering Springs to your Mazda 3 will result in a quicker turning response, crisper road feel, a more aggressive appearance, and a firmer spring rate, all while maintaining excellent ride quality.

The CorkSport Advantage:
  • Lower your car by approx. 2.25" front and 1.75" rear for improved handling and less wheel gap (lowest safe springs on the market)
  • Crafted from high tensile strength spring steel for long lasting quality and performance
  • OEM finish to ensure lasting durability and rust protection
  • Average 25% increased spring rate over stock spring rate
  • Backed by CorkSport limited two-year warranty
  • CorkSport Service and Support: Receive full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support



Install time                  3/5 Difficulty               2 year warranty       No CEL



This is an excellent product. I love these springs. An amazing noticeable drop! Thanks corksport!
Hi, I have 2012 skyactiv sedan, and I have fitted 20"x8.5 with offset of 35 and car has 20k miles. I was wondering if I would encounter any problems such as rubbing, bad camber, or need replace struts. I just want to make sure nothing goes wrong once installed.



CorkSport Reply:Give us a call 360-260-2675
I'm coming up on 35k miles on my 2011 Mazda 3 2.5, do I need to replace any other parts or can I just install these springs?



CorkSport Reply:Depending on road conditions you may or may not need to replace the struts and shocks based on the milage you have. If you want to be safe change the struts with you install the springs.
I have 2012 mazda 3 1.6 4dr, are these springs will work? or any recommendation.



CorkSport Reply:The springs will fit the 1.6 models but we are unsure of the amount they will lower compared to the North American models.
I read that you can drive with this drop of about 2 inches (average) with stock shocks/struts with low mileage vehicles; how does 20k miles sound?



CorkSport Reply:It depends on how the roads are in your area.
Are these springs going to fit my 2013 3i?



CorkSport Reply:Yes they will.
What's the recommended rim and tire size if I get the lowering springs



CorkSport Reply:There is no correct answer for your question, it comes down to what you want for function and style.

Are these springs a complete set of 4?



CorkSport Reply:Yes it is.
Hi, I was wondering if I install these springs does it affect the alignment or tow of the tires? I just put 17 inch rims and brand new Goodyear Eagle GT's on it and cannot void my tire warranty if the tires wear unevenly. Thanks



CorkSport Reply:We recommend an alignment with the installation of the springs. The toe at a minimum needs to be adjusted.
i have a 2010 mazda 3 hatchback with 48000 mil, can i just put these springs on right away or do i need something else?



CorkSport Reply: With 48,000 miles we would recommend installing the springs with new dampers.
Write a review

I have a 2012 Mazda 3 skyactive. I was wondering will these springs work okay with having a 225/45R18 set up with a 38mm offset. Will I need to roll the fenders, or will it cause issues to the tires from going over bumps?

Asked by Eric  | 10/19/2016, 09:16 AM | 1 answer(s)

ive upgraded my wheels from a 205/55/16 to a 225/30/20. can i still use these springs to lower my car?

Asked by preston botkin | 11/08/2016, 12:06 PM | 0 answer(s)

If im in a 2007 2.3 with speed3 18, 225/40/18 will these still fit alright? And what the warrenty?

Asked by Colton | 09/12/2016, 07:24 AM | 1 answer(s)

Hi, I got a Mazda 3 2011 hatch and was planning to buy some springs. But after asking 2 or 3 question. I heard that the back look to much higher compare to the front. I that real? Is there anything i can do to get them at the same level?

Asked by Jf Pratte | 08/13/2016, 04:16 PM | 1 answer(s)

MS3 2013 2.0 SKY. 225 /40 R18 . Will I need to roll? And what if I add 1/2 in wheel spacer? Thanks

Asked by Jonathan Marcil | 05/28/2016, 02:13 AM | 0 answer(s)

I want to compare these to other springs in regards to stiffness. What is the spring rate on these? Is it the same throughout or variable?

Asked by J Bradley | 12/25/2015, 12:33 PM | 1 answer(s)

I've got a 2006 3 but I have rx8 wheels and ½inch spacers so my tires stick out, will these still work with my car? Or will I have to roll my fenders?

Asked by Jake Schwefel | 11/10/2015, 04:16 PM | 1 answer(s)

I'm looking into purchasing 17x7.5 with a 35 offset for my 2012 3 hatchback with about 33,000 miles. Will I need to roll any fenders? And should I look into purchasing new shocks/structs? They are currently stock.

Asked by Christina R. | 10/22/2015, 01:47 PM | 1 answer(s)

Do I have to do any modifications to my shocks, structs, etc??? Can I just install the springs just like that?

Asked by Danny Herrera | 09/30/2015, 01:03 PM | 1 answer(s)

What is the rim size of the 3 pictured with the springs? And once installed what is the height from the ground? Thanks CS

Asked by Jason s | 09/10/2015, 10:09 PM | 1 answer(s)

Will these springs lower my 2007 Mazda 3 to much where I cant get over speed bumps or scrape everywhere?

Asked by Mikey | 09/08/2015, 06:05 AM | 1 answer(s)

In previous post you mention adding rear camber plates. Where can I buy those?

Asked by Jaye | 08/31/2015, 09:52 AM | 1 answer(s)

Would the stock wheels fit or would i have to get aftermarket wheels with the springs?

Asked by Deividas Tarasevicius | 08/18/2015, 05:33 AM | 1 answer(s)

Do you need to install a camber kit with the lowering springs? It won't effect the tires if i don't install the kit right?

Asked by Alex | 08/10/2015, 09:40 AM | 1 answer(s)

will this work on a 2013 skyactiv

Asked by xtian | 08/10/2015, 08:33 AM | 1 answer(s)

Do I need a camber kit after installing these as well?

Asked by Carlo | 04/28/2015, 03:02 PM | 3 answer(s)

how many springs come with the 2013 mazda 3 springs?

Asked by Saharat Suvarnapruksa | 07/04/2015, 01:33 PM | 1 answer(s)

Great drop height but a small issue is that it's making a lot more noise then usual

Asked by Samuel He | 06/24/2015, 03:31 PM | 1 answer(s)

These springs just replace the old factory springs right? Or do I need to by any other additional items to lower my 2012 Mazda 3?

Asked by Kyle Day | 06/24/2015, 03:30 PM | 1 answer(s)

Do you suggest getting sway bars to install after putting these in

Asked by Kyle | 06/24/2015, 03:29 PM | 1 answer(s)

will these springs be ok to use for daily driving and be able to go thru road bumps with no issues even on stock 17in wheels

Asked by josh | 06/03/2015, 05:19 PM | 1 answer(s)

Will these work with koni orange strut/shocks?

Asked by Gabrial  | 05/24/2015, 07:38 PM | 1 answer(s)

Do the springs fit the 2010 mazda 3, 1.6 petrol??

Asked by Nithin | 05/09/2015, 12:49 PM | 1 answer(s)

If I want to lower the back more than the front can I just switch it and use the 2.25 drop on the back 2 tires?

Asked by T Cruz | 05/05/2015, 07:39 AM | 1 answer(s)

Will these work on a 2008 Mazda 3 Sedan?

Asked by Fisher | 04/06/2015, 08:40 PM | 1 answer(s)

Will my car be fine if i put 5ppl in it with this aftermarket springs?

Asked by Mike | 03/30/2015, 10:17 AM | 1 answer(s)

Will a camber kit be required along with purchasing the lowering springs? Or can I just do an alignment once they are installed?

Asked by Rashon | 03/05/2015, 01:42 PM | 1 answer(s)

Will it fit on a mazda 3 2004 sedan ?

Asked by Felix | 02/28/2015, 05:20 AM | 1 answer(s)

Will I have to get aftermarket shocks if I want to put these on my mazda 3?

Asked by Blake | 02/17/2015, 07:09 AM | 1 answer(s)

I have a 2007 mazda 3 HB . Will these fit? And am I looking for the same lower ride height from stock

Asked by Nick  | 02/11/2015, 04:25 PM | 1 answer(s)

Can these be used on a 2008 mazda 3 hatchback?

Asked by Austin | 02/03/2015, 03:10 PM | 1 answer(s)

So these just swap original ones with these and that's it?

Asked by Matthew | 12/10/2014, 06:02 PM | 1 answer(s)

Will it fit on a 2011 mazda 3, 2.5?

Asked by Jimmy | 11/24/2014, 06:32 AM | 1 answer(s)

can these coilovers be used with adjustable shocks and struts

Asked by k jennex | 10/27/2014, 02:33 PM | 1 answer(s)

Six Months No Interest Financing on Purchases over $199!

Corksport understands that you may be ready to outfit your entire car with CorkSport Mazda Performance products, but want to use an alternative method of payment. Not to worry, we have a solution for you.

Click here for all the details of our Financing Options.