When designing an aftermarket rear swaybar, there are two main concerns, the weight of the bar, and the stiffness of the bar. The design chosen for the bar needs to be strong enough to resist chassis roll, while being light enough to keep weight down.
To battle the weight issue, we used a hollow tube for the main shaft of the bar. Hollow tubes are able to provide a greater torque resistance than a solid tube of equal weight. In addition, the two arms that connect the bar to the end links were optimized for weight by using finite element analysis. This allows me to design a bar that is structurally rigid, while removing material from areas of low stress. The image below simulates a load coming from the end link of the vehicle and the stresses that it puts on the arm. The deflection is exaggerated to give an idea of how the bar flexes during cornering.
The increased stiffness of the bar comes from increasing the diameter of the tube. To allow this, we utilized a set of larger diameter urethane bushings with greasable fittings. This allows for a more rigid mount, while giving you the option of greasing the bar without having to remove the bushings. The whole system is topped off by having 3 adjustable mount points of varying stiffness from 20% to 80% stiffer, while offering roughly 3 pounds of weight savings. The bar is powdercoated to protect it from the elements and keep it looking nice.
– Jake