Improve the ride and handling of your 2014-2018 Mazda 3 with the CorkSport Adjustable Struts and Shocks, Lowering Springs, and Camber Plates.
We’ve taken our performance lowering springs, rebound adjustable struts/shocks, and camber plates and combined them with quality OE pivot bearings, bump stops, and dust boots to create a complete package deal.
This package deal comes to your door pre-assembled and ready to install. No need to fight with a spring compressor or risk damaging the OE components that would typically be reused.
Not only is this a HUGE time saver, you also receive a package discount vs purchasing separately.
Performance Lowering Springs
The visual impact of performance lowering springs is astounding. With a drop of 1.75” front and 2.0” rear the vehicle takes on an aggressive, but functional look. The CorkSport Performance Lowering Springs are approximately 7% stiffer than OE providing a sporty and comfortable ride
.
Rebound Adjustable Struts and Shocks
Paired with the springs are 15-way rebound adjustable front struts and rear shocks. The gas charged twin-tube dampers provide tunable adjustment ranging from near OE rebound on the softest setting to significantly higher rebound stiffness allowing you to dial in your suspension characteristics.
.
Front Camber Adjustability
The front struts are assembled with CorkSport's camber plates to provide further flexibility in suspension setup depending on your wheel/tire setup and driving style. Maximum negative camber comes in at -1.5 degrees.
Easy Installation with OE Components
OE Mazda components are used to pre-assemble the front struts so they arrive at your door ready to install. No need to rent and use spring compressors to disassemble your old used parts.
New pivot bearings, bump stops, dust boots, and spring perch seats are used.
Vehicle Fitment: 2014-2018 Mazda3
CorkSport Service & Support:Receive a 1-year warranty, full-color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support at (360) 260-2675
Camber Plates increase the suspension noise transmitted into the vehicle chassis and cabin. Increased NVH is to be expected.
The camber plates must be adjusted off the car if the shock tower opening is not cut larger. The shock tower opening can be cut larger with a 3" hole saw for on car adjustability.
How To Install Your CorkSport Mazda3 Assembled Shock and Strut Package
It will take you one hour to install the CorkSport Assembled Shock and Strut Package with our easy-to-use instructions.
3 Hour Install Time
3/5 Difficulty
1-Year Warranty
No CEL
I used this kit to replace all the suspension on my 2014 GT. It was a little tricky to get the shock tops done in the front so I could adjust camber on the fly but not really too bad. Rides great, good stance, you cant go wrong.
