M-TH 9A-5P | F 9A-12P | SA-SU CLOSED
LOCATED: Vancouver, WA, USA
Shipping Estimator Shipping Estimator
- Menu
- New Products
- CorkSport Merch
- Mazda Performance Air Intake Systems
-
Mazdaspeed 3
- Mazda 3 Turbo
-
Mazda 3 Peformance Parts
- Mazdaspeed 6
- Mazda 6
- Mazda Miata/MX5
- Mazda CX3
- Mazda CX-30
- Mazda CX5
- Mazda CX-50
- Mazda CX7
- 2016+ Mazda CX9
- 2011-2013 Mazda 2
- Mazdaspeed Miata
- Mazdaspeed Protege
- Mazda Protege
- Mazda RX7
- Mazda RX8
- General Application
2014-2020 Mazda 6 SkyActiv Non-Turbo Power Series Short Ram Intake 2.5 Engine
Dramatically reduce intake restrictions and get an impressive improvement in power throughout the entire RPM range with the Mazda6 SkyActiv Short Ram Intake System.
Gains up to 6 Horsepower MAF housings engineered to exact tolerances and manufactured using the latest in computer-aided techniques. Machined from 6061-T6 aluminum.
- Designed Specifically for Mazda: All CorkSport parts have been designed and tested specifically for Mazdas.
- Velocity Stack Design: Smooths the incoming air flow and increases the flow rate of air and reduces turbulence.
- Durable Dry Flow Air Filter: Reusable and water resistant, this unique non-woven filter media does not require oil to filter and trap dirt and actually sheds dirt under engine vibration unlike cotton-gauze which holds contaminates until you clean the filter.
- Custom Reinforced Silicone Connectors: Constructed from multi-layer nylon braid to provide more strength and power and a smooth internal transition for less turbulence and optimal flow.
- Replacement Air Filter is: Available Here
- CorkSport Service and Support: Receive a 2 year warranty, full color installation instructions, all of the needed installation hardware, and knowledgeable telephone installation support.
**How to find your build date of your 2014-2020 Mazda 6. Open the drivers door and locate the vehicle identification sticker. It will look like the picture below. There will be a location which says date shown with the red arrow. That is what you need to find your build date. As you can see on the example below the Mazda was built in November 2012.
How To Install Your CorkSport Short Ram Intake
It will take you three hours to install the CorkSport Mazda6 SkyActiv SRI with our easy-to-use instructions.
1 Hour Install Time
1/5 Difficulty
2-Year Warranty
No CEL
good adding to my car.
like it even i have not tried others.
Intake sounds great when you get on it & full wail is amazing!
Throttle response is now immediate compared to the stock setup.
Fits 2016's no problem!
Short Ram Air Intake: Very quiet.
When stepping on the gas, I hear a nice growl sound that is not annoying, but good to the ears.
As for power gain, I can definitely feel the additional torque; it's not a crazy improvement, but definitely worth the money.
If you need to start somewhere with a mod to increase performance, check this little baby out.
Will this fit a non-US RHD 2.5l model?
We have sold these overseas in the past without issue.
Will this fit a 2021 mazda 6 touring (non-turbo)?
Yes, as long as it has the 2.5 NA motor
I recently bought over from my friend as he sold.his car already. But when i install it . Ytd it don sound very nice as compared to others i saw on youtoue. Then this morning when i start the vehicle there is CEL . .
Did you verify it is the right intake for your motor? Send any questions to sales@corksport.com
I watched the install video for the SRI...at about the 45 second mark he removes a short black tube from the bottom of the factory air box and places it on the front of the hood area. I don't see him replace it after the install...does this part not get put back on after replacing it? What does this tube go to? I have a 2019 Mazda 6 non turbo and have been looking for a site to get some mods...I think I have found my place here! Thank you.
The intake does not utilize the OEM airbox, so most of those components are not reinstalled.
When will the blue filters be available again?
We don't have an ETA on the filter deliveries yet.
I have a 2018 Mazda 6 with the 2.5L Skyactiv G (non turbo) engine. Just to confirm will this work on that engine?
It does not, the intake is different. This is the SRI that fits your motor: https://corksport.com/corksport-2014-mazda-6-skyactiv-power-series-short-ram-intake.html
I have a 2016 Mazda 6 2,5L. I'm considering buying this but I've read somewhere that the 2014-2018 Mazda3 & 2013-2017 Mazda6 Cold Air Box starves the engine when used. Can you verify this or did you do test with both the CAI and CAB? Also, to you ship to Belgium? Kind regards
We've never personally run into this issue, and we've made close to 200 Whp on the dyno with our header and the combination of those two. However, if this is something you have any concern with, you can always add some additional venting in the bottom of the box. We can ship to Belgium, however, USPS hasn't been completing shipping to certain countries due to their laws with COVID - 19. Please make sure you select the correct carrier when ordering to prevent this from happening.
Will this work on my 2018 Mazda6 non-turbo 2.5i
It will not. Contact our sales team about an intake for the non turbo Mazda 6 sales@corksport.com
Does this work with the 2013 Mazda 6 manual 2.2L diesal turbo?
It does not fit. We have an intake which is based on the GJ chassis 2.2 Skyactiv Diesel intake we made for Mazda to race the 25hours of thunderhill in 2014. https://corksport.com/2018-mazda-6-turbo-2.5l-short-ram-intake-system.html
When installing this I have read that you have to get your computer flashed. Is this true?
You can run it on the stock tune. To get the most power from the intake a tune is a good idea.
Does this effect the Mazda factory warranty?
It does not affect the warranty, you can confirm with your Mazda Dealer. However, some dealerships will put it on before they even sell it. But also will boil down to your area.
Hello some catalog for sky-diesel engines AT 175hp stage 1. Thanks
Sadly, we were never able to get these in the US so we have yet to be able to make power mods for the engine
I need to replace the filter, do you guys sell replacements and if not what are the dimensions of the filter itself?
Hello, The replacement filters are currently not listed on the website for the 2.5 L engines. Please give us a call and we can help you out.
Will this work on a Gen 3 Mazda 6 MY2017? 2.5L Skyactiv engine
Yes it will
I just got rid of my 2010 Mazdaspeed3. I still have the mass air flow housing from my corksport intake. Is this the same mass air flow housing? If so can I order the silicone elbow alone?
No. You need an entire new intake for that car.
does it fit the two types 2.0l and 2.5l engine?
This is specifically for the 2.5L.
Will you guys eventually make a heatshield for this intake ?
I do not have any information in regards to this, but if we do decide to release something like that we will have it posted all over our page.
Any updates for a 3rd gen Mazda 6 CAI?
No update yet. Just keep an eye on us.
someone is selling this short ram on craigslist... does it fit a 2013+ cx5?
If you have a 2.5 model Mazda 6 and it meets the production year criteria it will.
Are you working on a CARB SRI or CAI?
We are not. The cost to do CARB is around 12k.
I saw an option to put on your built day when you select the intake but now the option isn't there anymore. Does it matter when you put in the order?
As long as your Mazda 6 is newer than March 1st 2013 for the build date they are all the same. The option to select should be at the top of the page.
Is the SRI CARB legal?
This is not CARB legal.
Looking to finance your parts purchase and want to get 6 months NO interest on any purchase over $199? Click on the image above for more details.
Recommended Products Recommended Products
About CorkSport
ABOUT CORKSPORT
Connect
SPONSORSHIP
Install our webapp on your device
Tap on the
in the top right corner of the screen and "Add to homescreen"