We asked the CorkSport community for their ultimate Mazda performance questions for our new series, Ask the Expert. From the good to the bad to the weird, here are the top four questions straight from CS fans and our engineer’s answers.
Q: What is the maximum horsepower you can get from a MazdaSpeed 3 with just bolt-on’s?
A: With the typical bolt-on performance modifications from air filter to exhaust tip, you should be in the 320-330wHp and 340-360wTq range. You may be able to up those numbers a small amount with an E85 mixture, but for some locations that is not readily available. This is not including an exhaust manifold, intake manifold, or larger turbocharger. Now, if you were to add the exhaust manifold, intake manifold, and larger turbo (this being the largest power gain) then you will quickly find the limit of the fuel system at the 380-390whp range depending on the fuel grade/type.
Q: Will a supercharger/turbocharger kit become available for the SkyActiv platform?
A: This question has been stirring around since the release of the SkyActiv platform. With the release of the MX-5 with the 2.0L in the U.S. and the 1.5L in foreign markets I would not be surprised to see a supercharger and/or turbocharger kits being released in the next 1-2 years.
Q: What’s the boost threshold on the CorkSport Performance Drop-In Turbocharger?
A: We don’t have a compressor map to quote from, but I believe I can answer this fairly accurately from my knowledge and experience. The CorkSport turbo will be the most efficient in the 1.75 – 2.25 pressure ratio range. This equates to approximately 11 – 18psi, but this doesn’t mean the CS turbo will fall on its face in the higher boost levels. Due to the more efficient design of the forged billet compressor wheel, the CS turbo should stay above 75% efficiency until around pressure ratio 3 (30psi), and then begin to fall off a bit. At around pressure ratio 3.5 (36-37psi) you will be very close to the maximum shaft RPM for safe operation, so I wouldn’t push it past that. Either way, if you are running the CS turbo above 30psi, then bravo sir. I’m sure you have a very fun car.
Q: Here’s a hard one. If I have a manifold, which calipers should I buy to get a better exhaust sound?
A: Well the issue is you weren’t clear enough with your collection of parts. First off, what kind of manifold are we talking? Is it the manifold forged from Unobtanium with the blood, sweat, and tears of Santa’s Elves or is it the one and only manifold hand fabricated of carbon nano-tubes in the R&D lab at Koenigsegg designed by the alien race called…The Stig? And then you have the caliper… Do you mean the kind that grip locks the ferrous circular structure utilizing kinetic friction to cause conductive and convective heat transfer ultimately converting mechanical energy into thermal energy until it comes to a squealing stop or the kind that measures to the 0.001” and was used to design aforementioned caliper? See how I’m a little confused? Now we have four combinations to pick from and I could explain each and every one of them in great detail, but I don’t want to bore you. So the one I would pick goes as follows: Your cold start announces your presence like the trumpet of the Greek God Zeus riding his chariot into battle followed by your WOT pull roaring like a thousand lions chasing down a heard of Zebras.
via GIPHY
Cheers,
CorkSport